Workshop Repair Manuals

Volkswagen Workshop Manuals

[PREV PAGE] [NEXT PAGE]

volkswagen Workshop Repair Guides


Eos (1F7) V6-3.2L (BUB) (2008)

Relays and Modules > Relays and Modules - Brakes and Traction Control > Electronic Brake Control Module > Component Information > Service and Repair > ABS Mark 70, ABS and ASR > Page 158

Page 3
background image

-

Set the hydraulic unit with control module upward on to a clean, level surface.

-

Remove the inner Torx bolt from the control module.

-

Pull the control module off from the hydraulic unit in -  direction of arrow - without tilting.

-

Carefully pull off all sealing rings from the valve domes of the hydraulic unit.

CAUTION!
‹› On a disconnected control module, circuit board is laid open.

‹› No moisture or particles of dirt must penetrate in interior of control module.

‹› Avoid buildup of static electricity!

-

Cover control module magnetic coils with a lint free cloth.

After separating the control module and hydraulic unit, use the transport protection for valve body.

Installing New Control Module

CAUTION!
Excessive shaking (e.g. dropping, impact) may destroy the control module. Control module must then no longer be used.

‹› Surface must be cleaned before assembling.

-

Slide all the sealing rings - A - on slightly over the valve domes.

Relays and Modules > Relays and Modules - Brakes and Traction Control > Electronic Brake Control Module > Component Information > Service and Repair > ABS Mark 70, ABS and ASR > Page 158

[PREV PAGE] [NEXT PAGE]