Eos (1F7) V6-3.2L (BUB) (2008)
Headlamp Alignment Control Module: Service and Repair
Headlamp Range/Cornering Lamp Control Module J745
Headlamp Range/Cornering Lamp Control Module J745
Special tools, testers and auxiliary items required
-
Trim removal wedge VAS 3409
NOTE: When Removing and Installing components in a visible area (switches, covers, trim, etc.), mask off the areas at which a prying tool ( trim
removal wedge VAS 3409, screwdriver) will be positioned, using commercially available adhesive tape.
Removing
-
Switch off ignition, switch off all electrical components and remove ignition key.
-
Remove side cover - 1 - of instrument panel, do this by inserting trim removal wedge VAS 3409 or a screwdriver into recess - 2 - and pry off cover
- 1 - in - direction of arrow -.
-
Disengage securing bracket - 1 - in - direction of arrow - and disconnect harness connector - 2 - from Headlamp Range Control Module J431.