Eos (1F7) V6-3.2L (BUB) (2008)
-
Remove the vehicle electrical system control module - 2 - relay carrier in - direction of arrow B - from the bracket.
Installing:
Install in reverse order of removal, noting the following:
‹› The securing latch can only be brought into the CLOSED position when all connectors are correctly connected.
‹› If a new vehicle electrical system control module is installed, it must be coded. Refer to => [ Vehicle Electrical System Control Module, Coding,
Through 05.09 ] See: Testing and Inspection/Programming and Relearning.
Relay Carrier On Vehicle Electrical System Control Module, From 06.09
‹› The relay carrier is installed depending on the vehicle equipment level.
Removing:
-
Switch off ignition, switch off all electrical consumers and remove ignition key.
-
Remove the trim in the driver footwell.
-
Open both tabs - arrows - and pull the relay carrier - 2 - from the vehicle electrical system control module - 1 - opposite the drive direction.
-
Swing the relay carrier downward and unclip the relay. Pay attention the wire still connected.
Installing:
Install in reverse order.