Eos (1F7) V6-3.2L (BUB) (2008)
Hood Sensor/Switch (For Alarm): Service and Repair
Front Hood Switch
Removing
-
Switch off ignition, switch off all electrical components and remove ignition key.
-
Remove radiator grille.
-
Disconnect harness connector in the vicinity of the right headlamp - arrow -.
-
Unclip connector - 1 - in - direction of arrow - from lock carrier.
-
Remove mounting bolts - 2 - (12 Nm) and unclip wiring harness at mounting points - 3 -.
-
Remove lid lock from lock carrier.
NOTE: Bowden cable may remain connected to the lid lock.
-
Disengage retaining tab - 1 - and slide Front Hood Switch F266 in - direction of arrow -.
-
Remove contact switch from lid lock.
Installing
Install in reverse order of removal.