![]() |
Volkswagen Workshop Manuals | |
Eos (1F7) V6-3.2L (BUB) (2008)Sensors and Switches > Sensors and Switches - Body and Frame > Convertible Top Position Sensor / Switch > Component Information > Service and Repair > Roof Pillar Front Position Sensors![]() Convertible Top Position Sensor / Switch: Service and Repair Roof Pillar Front Position Sensors ‹› All screws are microencapsulated and must always be replaced. - Open roof. - Remove A-pillar trim. - Remove screw - 2 - and remove sensor - 1 - from lock fitting - 4 -. When replacing sensor, disconnect wire - 3 - approximately 350 mm from sensor. After repairing wiring harness, wiring must be secured in harness Tightening specification for screw - 2 -: 3 Nm. Sensors and Switches > Sensors and Switches - Body and Frame > Convertible Top Position Sensor / Switch > Component Information > Service and Repair > Roof Pillar Front Position Sensors | ||
[PREV PAGE] [NEXT PAGE] |