Workshop Repair Manuals

Volkswagen Workshop Manuals

[PREV PAGE] [NEXT PAGE]

volkswagen Workshop Repair Guides


Eos (1F7) V6-3.2L (BUB) (2008)

Sensors and Switches > Sensors and Switches - Engine > Oil Pressure Switch (For Fuel Pump) > Component Information > Testing and Inspection > Oil Pressure and Oil Pressure Switch, Checking > Page 816

Page 1
background image

Oil Pressure Switch (For Fuel Pump): Testing and Inspection
Oil Pressure Switch, Checking

Oil Pressure Switch, Checking

^

Bring lock carrier into service position. See: Body and Frame/Lock Carrier

^

Unscrew sealing plug from oil filter bracket. Collect escaping engine oil.

^

Seal the oil pressure switch test hole on oil pressure tester V.A.G. 1342 with the oil filter bracket sealing plug.

^

Screw oil pressure tester V.A.G. 1342 with adapter V.A.G. 1342/14 into oil filter bracket in place of sealing plug.

Note:
^

Note installation position of adapter: The conical connecting neck of the adapter is screwed to the pressure hose of the tester.

^

Connect brown wire of tester to Ground (GND) (-).

^

Connect voltage tester V.A.G. 1527B to B+ and oil pressure switch (connection in engine compartment -arrow-) using adapter cables from
connector test kit V.A.G. 1594C.
^

LED must not light up.

If the LED lights up:
^

Replace oil pressure switch F1.

If the LED does not light up:

Note:
^

While starting engine, watch Pressure Tester and LED as switch point of oil pressure switch may already be exceeded during start.

^

Start the engine and run at idle speed.

Sensors and Switches > Sensors and Switches - Engine > Oil Pressure Switch (For Fuel Pump) > Component Information > Testing and Inspection > Oil Pressure and Oil Pressure Switch, Checking > Page 816

[PREV PAGE] [NEXT PAGE]