Workshop Repair Manuals

Volkswagen Workshop Manuals

[PREV PAGE] [NEXT PAGE]

volkswagen Workshop Repair Guides


Eos (1F7) V6-3.2L (BUB) (2008)

Sensors and Switches > Sensors and Switches - Instrument Panel > Fuel Gauge Sender > Component Information > Locations > Page 918

Page 1
background image

Fuel Gauge Sender: Service and Repair

Fuel Level Sensor

‹› Phased in introduction of fuel delivery units with changed fuel level sensor (G).

Removing (Old Version)

-

Remove the fuel delivery unit. Refer to => [ Fuel Delivery Unit ] See: Powertrain Management/Fuel Delivery and Air Induction/Fuel
Pump/Service and Repair.

-

Note the color of the wire for installation later.

-

Release the connectors - arrows - and remove the electrical wires - 1, 2 and 3 -. Bend the retaining hooks on the connector back.

-

Lift the retaining tabs - 4 and 5 - with a screwdriver and pull the fuel level sensor downward and off - arrow  -.

Installing

-

Install the fuel level sensor in the guides on the fuel delivery unit and push upward until it engages.

-

Connect the connectors - 1 through 3 -. Note the color coding.

-

Pull on the connectors to make sure it is fastened securely.

-

Install the fuel delivery unit. Refer to => [ Fuel Delivery Unit ] See: Powertrain Management/Fuel Delivery and Air Induction/Fuel Pump/Service
and Repair.

Removing (new Version)

-

Remove the fuel delivery unit. Refer to => [ Fuel Delivery Unit ] See: Powertrain Management/Fuel Delivery and Air Induction/Fuel
Pump/Service and Repair.

-

Pull the fuel level sensor slightly to the side and simultaneously upward.

Sensors and Switches > Sensors and Switches - Instrument Panel > Fuel Gauge Sender > Component Information > Locations > Page 918

[PREV PAGE] [NEXT PAGE]