Workshop Repair Manuals

Volkswagen Workshop Manuals

[PREV PAGE] [NEXT PAGE]

volkswagen Workshop Repair Guides


Eos (1F7) V6-3.2L (BUB) (2008)

Sensors and Switches > Sensors and Switches - Lighting and Horns > Combination Switch > Component Information > Service and Repair > Steering Column Switch Overview, to 10.09 > Page 947

Page 4
background image

-

Insert a steel wire (approximately 1.2 mm) into the hole -  arrow - next to the ignition key.

-

Using the steel wire - 2 -, release - arrow  - the retaining lever - 3 - of the lock cylinder -  1 -.

-

Remove the lock cylinder - 1 - from the steering lock housing.

Installing:

-

Disconnect harness connector - arrow - at induction coil.

‹› To improve clarity, the ignition key is not shown in the following illustration.

-

Insert the ignition key into the lock cylinder - 1 - and turn it to the Run position.

Sensors and Switches > Sensors and Switches - Lighting and Horns > Combination Switch > Component Information > Service and Repair > Steering Column Switch Overview, to 10.09 > Page 947

[PREV PAGE] [NEXT PAGE]