Volkswagen Workshop Manuals
Eos (1F7) V6-3.2L (BUB) (2008)
Sensors and Switches > Sensors and Switches - Powertrain Management > Sensors and Switches - Computers and Control Systems > Camshaft Position Sensor > Component Information > Locations > Page 1018
Specified value: about 5.0 V
Switch the ignition off.
If the specification was not obtained:
If the manufacturers test box is being used. Perform the following step.
Install the Test Box 105 Pin (VAG1598/31).
If the manufacturers test box is not being used. Perform the following step.
Remove the Engine Control Module (ECM) (J623). Refer to => [ Engine Control Module J623, Replacing ] See: Powertrain
Using a Multimeter, Check the Camshaft Position (CMP) Sensor (G40) or Camshaft Position (CMP) Sensor 2 (G163) electrical harness connector
|[PREV PAGE] [NEXT PAGE]|