Workshop Repair Manuals

Volkswagen Workshop Manuals

[PREV PAGE] [NEXT PAGE]

volkswagen Workshop Repair Guides


Eos (1F7) V6-3.2L (BUB) (2008)

Sensors and Switches > Sensors and Switches - Powertrain Management > Sensors and Switches - Computers and Control Systems > Coolant Temperature Sensor/Switch (For Computer) > Component Information > Testing and Inspection > Engine Coolant Temperature (ECT) Sensor (on Radiator) G83, Checking > Page 1025

Page 3
background image

If the DTC does not return:
Repair complete, Generate readiness code.  See: Powertrain Management/Computers and Control Systems/Testing and Inspection/Monitors, Trips, Drive
Cycles and Readiness Codes

-

End diagnosis.

If the DTC does return and no malfunction is detected in the wiring and the voltage supply was OK:

-

Replace the Engine Control Module (ECM) J623.

-

Assembly is performed in the reverse of the removal.

Final procedures

After repair work, the following work steps must be performed in the following sequence:

1. Check the DTC memory.  
2. If necessary, erase the DTC memory.  
3. If the DTC memory was erased, generate readiness code.  See: Powertrain Management/Computers and Control Systems/Testing and

Inspection/Monitors, Trips, Drive Cycles and Readiness Codes

-

End of diagnosis.

Sensors and Switches > Sensors and Switches - Powertrain Management > Sensors and Switches - Computers and Control Systems > Coolant Temperature Sensor/Switch (For Computer) > Component Information > Testing and Inspection > Engine Coolant Temperature (ECT) Sensor (on Radiator) G83, Checking > Page 1025

[PREV PAGE] [NEXT PAGE]