![]() |
Volkswagen Workshop Manuals | |
Eos (1F7) V6-3.2L (BUB) (2008)Sensors and Switches > Sensors and Switches - Powertrain Management > Sensors and Switches - Computers and Control Systems > Knock Sensor > Component Information > Locations > Page 1046![]() Knock Sensor: Testing and Inspection Knock Sensor, Checking The following procedure is used to diagnose Knock Sensor (KS) 1 (G61)/Knock Sensor (KS) 2 (G66 ). Special tools, testers and auxiliary items required ‹› Multimeter. ‹› Wiring diagram. Test requirements ‹› The mounting bolt of Knock Sensor (KS) 1 (G61)/Knock Sensor (KS) 2 (G66) tightened to 20 Nm. ‹› The Engine Control Module (ECM) ( J623) fuses OK. ‹› Battery voltage at least 12.5 volts. ‹› All electrical consumers such as, lights and rear window defroster, switched off. ‹› Vehicles with automatic transmission, shift selector lever into position " P" or "N". ‹› A/C switched off. ‹› Ground (GND) connections between engine/transmission/chassis OK. ‹› Ignition switched off. Test procedure - Perform a preliminary check to verify the customers complaint. Refer to => [ Preliminary Check ] See: Powertrain Management/Computers and Start diagnosis ‹› Before disconnecting the Knock Sensor electrical harness connectors, mark the component location. - Disconnect the green Knock Sensor (KS) 1 (G61 ) electrical harness connector- 1 - or the gray Knock Sensor (KS) 2 (G66) electrical harness Checking internal resistance - Using a Multimeter, check the Knock Sensor terminals 1 to 2 for an internal short. Sensors and Switches > Sensors and Switches - Powertrain Management > Sensors and Switches - Computers and Control Systems > Knock Sensor > Component Information > Locations > Page 1046 | ||
[PREV PAGE] [NEXT PAGE] |