Eos (1F7) V6-3.2L (BUB) (2008)
Acceleration Sensor: Service and Repair
Rear Body Acceleration Sensor
Rear Body Acceleration Sensor
Special tools, testers and auxiliary items required
‹› Torque wrench (V.A.G 1410)
Removing
-
Remove wheel.
-
Remove the left rear wheel housing liner.
-
Release and disconnect the connector.
-
Remove the screws and remove the rear body acceleration sensor (G343).
Installing
Installation is performed in the reverse order of removal. Observe the following when doing so:
CAUTION!
The rear body acceleration sensor must never be interchanged with the front body acceleration sensors.
-
Note the rear body acceleration sensor installation position on the retainer.