![]() |
Volkswagen Workshop Manuals | |
Eos (1F7) V6-3.2L (BUB) (2008)Sensors and Switches > Sensors and Switches - Steering and Suspension > Sensors and Switches - Suspension > Ride Height Sensor, Suspension Control > Component Information > Service and Repair > Procedures > Page 1232![]() ‹› Complete with components ‹› Lever - arrow - must point toward vehicle exterior. ‹› Removing and installing, refer to => [ Left Rear Level Control System Sensor ] See: Left Rear Level Control System Sensor. ‹› If the left rear level control system sensor was removed and then installed, then a basic setting to the adaptive chassis must be performed. Refer to => [ Adaptive Chassis DCC, Basic Setting ] See: Steering and Suspension/Suspension/Suspension Control ( Automatic - Electronic ‹› After replacing, perform basic setting of the headlamps via the Guided Fault Finding function with the Vehicle Diagnosis, Testing, and Information System (VAS 5051). 4 Lower Transverse Link Front Level Control System Sensor Front Level Control System Sensor Special tools, testers and auxiliary items required ‹› Torque wrench (V.A.G 1331) ‹› Vehicle Diagnosis, Testing, and Information System ( VAS 5051) Removing ‹› In order to be able to remove the left front level control system sensor (G78) the steering wheel must be turned all the way to the right; this assures that there is enough clearance between the control arm and the stabilizer bar. ‹› In order to be able to remove the right front level control system sensor (G289) the steering wheel must be turned all the way to the right; this assures that there is enough clearance between the control arm and the stabilizer bar. - Disconnect the connector. - Remove the screw and the nut. - Remove level control system sensor. Installing Installation is performed in the reverse order of removal. Observe the following when doing so: ‹› The level control system sensor lever must point toward vehicle exterior. ‹› The thread on the vehicle level sensor must be installed into the front hole in the control arm. The tab on the vehicle level sensor retainer must lock Sensors and Switches > Sensors and Switches - Steering and Suspension > Sensors and Switches - Suspension > Ride Height Sensor, Suspension Control > Component Information > Service and Repair > Procedures > Page 1232 | ||
[PREV PAGE] [NEXT PAGE] |