Eos (1F7) V6-3.2L (BUB) (2008)
Remote Battery Jumper Terminal: Service and Repair
External Starter Point with Suppressor
Special tools, testers and auxiliary items required
-
Torque wrench V.A.G 1331
Removing
-
Turn off the ignition and all electrical components.
-
Disconnect battery.
NOTE: Air filter housing is removed for reasons of clarity. It is not required when doing repairs.
-
Disengage retaining clip - arrow A - and open cover - 1 - over positive pole pick-up.
-
Disengage cover - 2 - over electrical wires in - direction of arrow B -.
-
Remove mounting nuts - 5 - and - 6 - on positive wires.
-
Disconnect electrical harness connector - 1 - at suppressor - 4 -.
-
Remove bolt - 3 - and remove positive pole pick-up - 2 - with suppressor from retainer.
Installing
Install in reverse order of removal.
-
Tighten all threaded connections to specified tightening torque.
-
Reconnect battery.