Workshop Repair Manuals

Volkswagen Workshop Manuals

[PREV PAGE] [NEXT PAGE]

volkswagen Workshop Repair Guides


Eos (1F7) V6-3.2L (BUB) (2008)

Starting and Charging > Power and Ground Distribution > Wiring Harness > Component Information > Service and Repair > Procedures > Page 4693

Page 12
background image

‹› In the event the repair point was previous taped, this point must be taped anew with yellow insulating tape after repairs.

‹› Secure the repaired wiring harness if necessary with a cable tie to prevent flapping noises while driving.

Contacts In Contact Housing, Repairing

Contacts in Contact Housing, Repairing

-

First, open or release if necessary the secondary lock of the contact housing. Refer to => [ Secondary Lock ] See: Description and
Operation/Secondary Lock.

-

Release contact (primary lock) using the appropriate release tool. Refer to => [ Primary Lock ] See: Description and Operation/Primary Lock.

-

Pull contact at single wire out of contact housing.

-

Take the yellow repair wire with the correct contact out of the Wiring Harness Repair Set.

-

Free up repair point of vehicle-specific wiring harness (approximately 20 cm to both sides of repair point).

-

If required, remove wiring harness wrapping using a folding knife.

-

Insert new contact of repair wire into contact housing until it engages.

Starting and Charging > Power and Ground Distribution > Wiring Harness > Component Information > Service and Repair > Procedures > Page 4693

[PREV PAGE] [NEXT PAGE]