Workshop Repair Manuals

Volkswagen Workshop Manuals

[PREV PAGE] [NEXT PAGE]

volkswagen Workshop Repair Guides


Eos (1F7) V6-3.2L (BUB) (2008)

Starting and Charging > Power and Ground Distribution > Wiring Harness > Component Information > Service and Repair > Procedures > Page 4695

Page 14
background image

chapter => [ Wire Break with Single Repair Point ] See: Wire Break With Single Repair Point.

  ‹› Make sure that crimp connections do not lie directly next to each other when several wires need to be repaired. Arrange the crimp connectors at a

slight offset so that the circumference of the wiring harness does not become too large.

‹› In the event the repair point was previous taped, this point must be taped anew with yellow insulating tape after repairs.

‹› Secure the repaired wiring harness if necessary with a cable tie to prevent flapping noises while driving.

Contact Housings, Repairing Wire Terminals

Contact Housings, Repairing Wire Terminals

  ‹› For technical reasons, the contact housing for the wire terminals can be supplied only with the contacts pushed in.

Starting and Charging > Power and Ground Distribution > Wiring Harness > Component Information > Service and Repair > Procedures > Page 4695

[PREV PAGE] [NEXT PAGE]