Eos (1F7) V6-3.2L (BUB) (2008)
Front Axle Camber, Correcting
Special tools, testers and auxiliary items required
‹› Torque wrench (V.A.G 1332)
‹› Camber correction is required only after repair work on chassis. Camber is not adjustable but can be rearranged by moving brackets and/or
‹› Slide subframe only toward left or right, under no circumstances in or against direction of travel!
Remove noise insulation.
Loosen bolts - 1 - for console mount/subframe on body on both sides.
The possible range of camber setting in bracket and subframe holes is restricted by tolerances. If specified value is not reached by sliding components,
these and the body must be checked. Refer to => [ Evaluating Suspension on Vehicles Involved in Accidents ] See: Suspension/Service and
Repair/Procedures/Evaluating Suspension on Vehicles Involved in Accidents.
By sliding subframe with console, specified value for camber can now by set.
Tighten subframe and brackets with new bolts on body to additional torque angle.
‹› After sliding subframe and steering gear along with it as well, clearance between universal joint of steering column and cutout of bulkhead must be
Remove securing nuts - arrows - and remove foot well trim.