Workshop Repair Manuals

Volkswagen Workshop Manuals

[PREV PAGE] [NEXT PAGE]

volkswagen Workshop Repair Guides


Eos (1F7) V6-3.2L (BUB) (2008)

Steering and Suspension > Relays and Modules - Steering and Suspension > Relays and Modules - Suspension > Suspension Control Module > Component Information > Service and Repair > Electronic Damping Control Module (J250) > Page 5135

Page 1
background image

Suspension Control Module: Service and Repair
Electronic Damping Control Module

Electronic Damping Control Module

Removing

‹› Component location: Behind the left side luggage compartment trim panel. 

-

Switch off all electrical consumers.

-

Remove the ignition key.

-

Remove the left side trim in the luggage compartment.

-

Release and disconnect the connector.

-

Slightly bend the tabs on the bracket - arrows - upward and slide the electronic damping control module (J250) in - direction of arrow - out of
the bracket.

Installing

Installation is the reverse of removal, with special attention to the following:

-

Slide the electronic damping control module far enough into the bracket so that the tabs - arrows - audibly latch into place. 

-

Perform a basic setting on the adaptive chassis DCC. Refer to => [ Adaptive Chassis DCC, Basic Setting ] See: Suspension/Suspension Control (
Automatic - Electronic )/Testing and Inspection/Programming and Relearning.

Steering and Suspension > Relays and Modules - Steering and Suspension > Relays and Modules - Suspension > Suspension Control Module > Component Information > Service and Repair > Electronic Damping Control Module (J250) > Page 5135

[PREV PAGE] [NEXT PAGE]