Workshop Repair Manuals

Volkswagen Workshop Manuals

[PREV PAGE] [NEXT PAGE]

volkswagen Workshop Repair Guides


Eos (1F7) V6-3.2L (BUB) (2008)

Steering and Suspension > Sensors and Switches - Steering and Suspension > Sensors and Switches - Suspension > Ride Height Sensor, Suspension Control > Component Information > Service and Repair > Procedures > Page 5179

Page 7
background image

into the rear hole in order to assure a correct installation position. 

-

Perform a basic setting on the adaptive chassis DCC. Refer to => [ Adaptive Chassis DCC, Basic Setting ] See: Suspension/Suspension Control (
Automatic - Electronic )/Testing and Inspection/Programming and Relearning.

-

Perform a basic setting on the headlamps via the Guided Fault Finding function with the (VAS 5051).

Tightening Specifications

Left Rear Level Control System Sensor

Left Rear Level Control System Sensor

Special tools, testers and auxiliary items required

‹› Torque wrench (V.A.G 1331)

‹› Vehicle Diagnosis, Testing, and Information System ( VAS 5051)

Removing

-

Disconnect the connector.

-

Remove the bolts.

-

Remove left rear level control system sensor ( G76).

Installing

Installation is performed in the reverse order of removal. Observe the following when doing so:

The level control system sensor lever must point toward vehicle exterior. 

-

Perform a basic setting on the adaptive chassis DCC. Refer to => [ Adaptive Chassis DCC, Basic Setting ] See: Suspension/Suspension Control (
Automatic - Electronic )/Testing and Inspection/Programming and Relearning.

-

Perform a basic setting on the headlamps via the Guided Fault Finding function with the (VAS 5051).

Tightening Specifications

Steering and Suspension > Sensors and Switches - Steering and Suspension > Sensors and Switches - Suspension > Ride Height Sensor, Suspension Control > Component Information > Service and Repair > Procedures > Page 5179

[PREV PAGE] [NEXT PAGE]