Eos (1F7) V6-3.2L (BUB) (2008)
Suspension Control Pressure Sensor/Switch: Service and Repair
Left Rear Level Control System Sensor
Special tools, testers and auxiliary items required
‹› Torque wrench (V.A.G 1410)
Disconnect the connector - 1 -.
Remove the bolts - 2 - from the lower transverse link.
Remove bolts - arrows - from the subframe.
Remove left rear level control system sensor ( G76).
Installation is performed in the reverse order of removal. Observe the following when doing so:
‹› The left rear level control system sensor lever must point toward the outside of the vehicle.
After replacing, perform a headlamp basic setting via the Guided Fault Finding function with the Vehicle Diagnostic, Testing and Information
System (VAS 5051).