Workshop Repair Manuals

Volkswagen Workshop Manuals

[PREV PAGE] [NEXT PAGE]

volkswagen Workshop Repair Guides


Eos (1F7) V6-3.2L (BUB) (2008)

Steering and Suspension > Suspension > Wheel Bearing > Component Information > Service and Repair > Procedures > Page 5755

Page 4
background image

‹› Before inserting wheel speed sensor, clean inner surface of bore hole and coat with securing grease (G 000 650)

4

Bolt

‹› M6 x 16

‹› 8 Nm

5

Tie Rod End

6

Wheel Hub with Wheel Bearing

‹› Removing and installing, refer to => [ Wheel Bearing Unit ] See: Front Suspension/Wheel Bearing Unit. 

‹› The ABS sensor ring is installed in the wheel bearing.

‹› Various versions.

7

Nut

‹› M12 x 1.5

‹› 20 Nm + 90° turn

‹› Self-locking

‹› Always replace after removal.

8

Internally Vented Brake Disc

9

Bolt

‹› M16 x 1.5 x 80

‹› Hex head bolt: 200 Nm + 180° turn

‹› Twelve-point bolt: 70 Nm + 90° turn

‹› Always replace after removal.

CAUTION!
Vehicle must not be standing on its wheels when loosening or tightening.

10

Bolt

11

Bolt

‹› 12 Nm

12

Cover Plate

13

Wheel Bearing Housing

‹› Removing and installing, refer to => [ Wheel Bearing Housing ] See: Front Suspension/Wheel Bearing Housing. 

‹› With bolted brake carrier.

‹› If a wheel bearing housing is replaced, vehicle must then be aligned. Refer to => [ Wheel Alignment ] See: Alignment/Service and

Repair/Wheel Alignment.

14

Bolt

‹› M12 x 1.5 x 45

‹› 70 Nm + 90° turn

Steering and Suspension > Suspension > Wheel Bearing > Component Information > Service and Repair > Procedures > Page 5755

[PREV PAGE] [NEXT PAGE]