Workshop Repair Manuals

Volkswagen Workshop Manuals

[PREV PAGE] [NEXT PAGE]

volkswagen Workshop Repair Guides


Eos (1F7) V6-3.2L (BUB) (2008)

Transmission and Drivetrain > Automatic Transmission/Transaxle > Relays and Modules - A/T > Control Module, A/T > Component Information > Testing and Inspection > CAN-Bus Terminal Resistance, Direct Shift Gearbox (DSG) Mechatronic J743 To Engine Control Module (ECM) J623, Checking > Page 3523

Page 1
background image

Control Module: Testing and Inspection
Voltage Supply of Direct Shift Gearbox (DSG) Mechatronic J743, Checking

Voltage Supply Of Direct Shift Gearbox (DSG) Mechatronic J743, Checking

Special tools, testers and auxiliary items required

-

Multimeter.

-

Wiring diagram.

Test requirements

-

The Direct Shift Gearbox (DSG) Mechatronic J743 fuses OK.

-

The Power Supply Relay (terminal 15) J329 OK.

-

Battery voltage at least 12.5 volts.

-

All electrical consumers such as, lights and rear window defroster, switched off.

-

Selector lever in "P" or "N".

-

A/C switched off.

-

Ground (GND) connections between engine/transmission/chassis OK.

-

Ignition switched off.

Test procedure

-

Perform a preliminary check to verify the customers complaint.  See: Powertrain Management/Computers and Control Systems/Testing and
Inspection/Scan Tool Testing and Procedures/Preliminary Check

Start diagnosis

-

Disconnect the Direct Shift Gearbox (DSG) Mechatronic J743 electrical harness connector - 1 - by rotating counterclockwise.

Checking voltage supply, terminal 30

-

Using a Multimeter, check the Direct Shift Gearbox (DSG) Mechatronic J743 electrical harness connector terminals for voltage.

Direct Shift Gearbox (DSG) Mechatronic J743 electrical harness connector terminals
11 to 16
11 to 19

Specified value: battery voltage.

If the specified value was not obtained:

-

Check the wiring connection for an open circuit, short circuit to Battery (+) or Ground (GND).

-

Check the wiring connection for damage, corrosion, lose or broken terminals.

-

If necessary, repair the faulty wiring connection.

If the wiring and voltage were OK:

Voltage supply, terminal 15

-

Using a Multimeter, check the Direct Shift Gearbox (DSG) Mechatronic J743 electrical harness connector terminals for voltage.

Direct Shift Gearbox (DSG) Mechatronic J743 electrical harness connector terminals
18 to 16
18 to 19

Specified value: battery voltage.

Transmission and Drivetrain > Automatic Transmission/Transaxle > Relays and Modules - A/T > Control Module, A/T > Component Information > Testing and Inspection > CAN-Bus Terminal Resistance, Direct Shift Gearbox (DSG) Mechatronic J743 To Engine Control Module (ECM) J623, Checking > Page 3523

[PREV PAGE] [NEXT PAGE]