Volkswagen Workshop Manuals
Eos (1F7) V6-3.2L (BUB) (2008)
Transmission and Drivetrain > Drive Axles, Bearings and Joints > Wheel Bearing > Component Information > Service and Repair > Procedures > Page 3668
Using a ratchet and the (3424), open the wheel bearing housing slot.
Loosen nuts - arrows -.
Now place (V.A.G 1383 A) under wheel bearing housing.
First press off ball joint from control arm in order to then pull off the wheel bearing housing from suspension strut.
‹› If the wheel bearing housing is being replaced, then the ball joint must also be replaced. Use new nuts.
Installation is the reverse of removal, with special attention to the following:
Tighten drive axle bolt to wheel hub:
‹› Hex head bolt, refer to => [ Drive Axle Hex Bolt Connection, Loosening and Tightening ] See: Wheel Hub/Axle Nut/Service and Repair/Removal
‹› Twelve point bolt, refer to => [ Drive Axle Twelve-Point Bolt, Loosening and Tightening ] See: Wheel Hub/Axle Nut/Service and
‹› Vehicle must not be standing on its wheels when doing this, otherwise wheel bearing will be damaged.
If a wheel bearing housing was replaced, vehicle must be aligned. Refer to => [ Wheel Alignment ] See: Maintenance/Alignment/Service and
Install wheel and tighten. Refer to => [ Wheel Bolt Tightening Specification ] See: Maintenance/Wheels and Tires/Wheel Fastener/Specifications.
|[PREV PAGE] [NEXT PAGE]|