Workshop Repair Manuals

Volkswagen Workshop Manuals

[PREV PAGE] [NEXT PAGE]

volkswagen Workshop Repair Guides


Eos (1F7) V6-3.2L (BUB) (2008)

Transmission and Drivetrain > Manual Transmission/Transaxle > Sensors and Switches - M/T > Transmission Speed Sensor, M/T > Component Information > Locations > Page 3747

Page 1
background image

Transmission Speed Sensor: Service and Repair

Transmission Input Speed Sensor and Clutch Oil Temperature Sensor

Short Description

Both sensors are combined into one component and can only be replaced together. They are coated with oil in the transmission near the multi-plate
clutch. Before removing, the Direct Shift Gearbox (DSG) Mechatronic Unit (J743) must be removed.

Often, the sensor wire is pulled on. This damages it. If the wire was pulled on, the sensor must be replaced.

Removing

-

Remove the Mechatronic unit. Refer to => [ Mechatronic Unit, Transmission Installed ] See: Gearshift Actuating System - M/T/Service and
Repair/Mechatronic Unit, Transmission Installed.

Do not pull on the wire!

-

Remove the bolt and carefully pry out the sensor using a screwdriver or pliers.

Installing

Only install the old sensor, if it is certain that:

‹› The sensor functions properly.

‹› The wire was not pulled on during removal.

If this is not the case, you should install a new sensor.

-

Install the sensor lubricated with DSG oil.

-

Tighten the bolt to 10 Nm.

-

Install the Mechatronic unit. Refer to => [ Mechatronic Unit, Transmission Installed ] See: Gearshift Actuating System - M/T/Service and
Repair/Mechatronic Unit, Transmission Installed.

One special request:

Transmission and Drivetrain > Manual Transmission/Transaxle > Sensors and Switches - M/T > Transmission Speed Sensor, M/T > Component Information > Locations > Page 3747

[PREV PAGE] [NEXT PAGE]