Workshop Repair Manuals

Volkswagen Workshop Manuals

[PREV PAGE] [NEXT PAGE]

volkswagen Workshop Repair Guides


Eos (1F7) V6-3.2L (BUB) (2008)

Transmission and Drivetrain > Transmission Control Systems > Sensors and Switches - Transmission and Drivetrain > Sensors and Switches - M/T > Hydraulic Fluid Temperature Sensor - M/T > Component Information > Service and Repair

Page 1
background image

Hydraulic Fluid Temperature Sensor - M/T: Service and Repair

Transmission Input Speed Sensor and Clutch Oil Temperature Sensor

Short Description

Both sensors are combined into one component and can only be replaced together. They are coated with oil in the transmission near the multi-plate
clutch. Before removing, the Direct Shift Gearbox (DSG) Mechatronic Unit (J743) must be removed.

Often, the sensor wire is pulled on. This damages it. If the wire was pulled on, the sensor must be replaced.

Removing

-

Remove the Mechatronic unit. Refer to => [ Mechatronic Unit, Transmission Installed ] See: Manual Transmission/Transaxle/Gearshift Actuating
System - M/T/Service and Repair/Mechatronic Unit, Transmission Installed.

Do not pull on the wire!

-

Remove the bolt and carefully pry out the sensor using a screwdriver or pliers.

Installing

Only install the old sensor, if it is certain that:

‹› The sensor functions properly.

‹› The wire was not pulled on during removal.

If this is not the case, you should install a new sensor.

-

Install the sensor lubricated with DSG oil.

-

Tighten the bolt to 10 Nm.

-

Install the Mechatronic unit. Refer to => [ Mechatronic Unit, Transmission Installed ] See: Manual Transmission/Transaxle/Gearshift Actuating
System - M/T/Service and Repair/Mechatronic Unit, Transmission Installed.

One special request:

Transmission and Drivetrain > Transmission Control Systems > Sensors and Switches - Transmission and Drivetrain > Sensors and Switches - M/T > Hydraulic Fluid Temperature Sensor - M/T > Component Information > Service and Repair

[PREV PAGE] [NEXT PAGE]