Eurovan L5-2369cc 2.4L DSL SOHC (AAB) Can (1993)
Rear Door Window Glass: Service and Repair
Body Flange And/or Window Flange on Door, Preparing
Body Flange And/or Window Flange On Door, Preparing
-
Cut back remaining adhesive material on body flange to 1 to 2 mm (1/32 to 5/64 in.) height with electric cutting tool VAG 1561 and scraping
knife VAG 1561/8.
NOTE: Do not remove adhesive completely. It is used as a base for new adhesive material.
CAUTION: Do not prime or activate adhesive surface or treat it with cleaning solution. Keep adhesive surface dirt and grease free.
Exception:
If gluing will not take place immediately after cutting back, remaining residual material must be activated with activator AMV 181 800 02 or equivalent.
-
If body flange at area of glass is being worked on or replaced flange must be cleaned and primed after painting.