Eurovan L5-2369cc 2.4L DSL SOHC (AAB) Can (1993)
_can/Page-166004.png)
-
Bring ATF to test temperature.
Test temperature: 35°C to 45°C
-
Remove ATF level plug from the oil pan.
The ATF present in the overflow pipe (arrow 2) runs out.
-
Observe amount of ATF draining from plug hole afterward.
If ATF drips out of the hole:
ATF need not be topped up.
-
Install new seal (arrow 1) to plug and tighten to 15 Nm, ATF check is completed.
Sealing plug (arrow 3) and cap (arrow 4) remain closed.
If the ATF present in the overflow pipe runs out of the plug hole but no further draining is observed:
-
Top up ATF in transmission.
ATF, topping off
With engine running.
-
Pry off plug securing cap -arrow- with a screwdriver. The cap locking device will be destroyed, when doing this therefore always replace cap.
