Eurovan L5-2369cc 2.4L DSL SOHC (AAB) Can (1993)
Screw turned outwards (clearance at timing lever)
Residual volume is too small. This leads to performance complaints such as "flat spots" when starting off and/or accelerating from low engine speeds
and/or experiencing jerking in all gears
If the above complaints are heard
-
Perform following basic setting on residual volume adjusting screw -2-
-
Remove anti-tamper cap
-
Release adjusting screw -2- lock nut
Residual volume is too small
-
Screw in adjusting screw until idle speed increases
-
from point at which speed increase starts, turn adjusting screw back a half turn
-
Lock adjusting screw and secure with new anti-tamper cap
Residual volume too great (engine speed too high)
-
Turn adjusting screw out until idle speed no longer decreases
-
Turn adjusting screw in again until idle speed starts to increase
-
from point at which engine speed starts to increase, turn adjusting screw back a half turn
-
Lock adjusting screw and secure using new anti-tamper cap