Eurovan L5-2369cc 2.4L DSL SOHC (AAB) Can (1993)
-
2K adhesive compound must be mixed according to supplied instructions.
-
Window must be installed within 15 minutes otherwise adhesion of adhesive sealing material will be reduced.
-
Install window in opening using two double suction pads (VAG 1344).
-
Align window and press into window opening as follows:
Molding (Repair Profile), Installing
The production molding is removed.
-
Spray glass edge with D 009 401 04 lubricant.
-
Place repair molding in middle lower area -arrow A- and fasten along window cutout -arrow B-.
-
Cut repair molding approximately 4 mm (0.15 in.) longer.
-
Apply Cyan acrylic adhesive AMV 195 KD1 to repair molding end.
-
Repair molding end should also be attached -arrow A-.
-
Press repair molding -arrow B- together and hold for five seconds.
-
Install remainder of seal in window cut out.
Side and Rear Window, Removing/Installing