Eurovan L5-2369cc 2.4L DSL SOHC (AAB) Can (1993)
Windshield: Service and Repair
Windshield, Unbroken Side Windows And Unbroken Rear Windows, Removing
Windshield, Unbroken Side Windows And Unbroken Rear Windows, Removing
CAUTION: Always wear protective goggles and leather gloves when removing/installing glass.
NOTE: To remove windshield, spool VAG 1654 can also be used.
-
To remove windshield, unscrew windshield wiper and disconnect windshield antenna connection.
Inside mirror, removing
-
To remove rear window, disconnect rear window heating element.
-
Pull window molding completely off window.
-
Mask window opening.
-
Push awl (from VAG 1474) through sealing bead from inside vehicle.
NOTE: For windshield, push awl through at lower left or lower right corner.
-
Adjust cutting wire to 350 - 400 mm (approx. 14 to 15 3/4 in.) and pull through sealing compound from outside with awl.
NOTE:
-
Two technicians required to remove windshield
-
Specified method for cutting out windshield must be followed
-
Do not cut out windshield using sawing motions. This will heat wire and cause it to break. Wire can also break if it becomes twisted or bent.
-
Fasten cutting wire with wire ends on bracket - 1 - (inside vehicle) and handle - 2 - (outside vehicle).
-
Insert handle - 1 - into adhesive sealing component and hold in direction of - arrow A -.
-
Use pulling handle - 2 -, pull wire evenly in direction of - arrow B - to stopping point - 3 -.
-
Pull wire with handle - 1 - approx. 100-500 mm (approx. 4 to 20 in.) toward the inside, insert handle - 1 - on adhesive material again and hold.
Cut to next stopping point.