Eurovan V6-2.8L (AXK) (2001)
-
Bolted at bottom of B-pillar.
-
Tightening torque: 40 Nm (30 ft lb).
4
-
Spring clip
5
-
Locating tab in roller guide
-
Clamp must be centered
-
Incorrect installation of spring clip can cause damage to upper B-pillar trim by sliding door.
6
-
Sliding door gasket
7
-
Clip
-
Two-piece
-
Install sleeve in B-pillar hole, install pin in trim.
Upper B-Pillar Trim (Right), Removing/Installing
Upper B-pillar Trim (Right), Removing/Installing
-
Remove seat belt anchor cap and hex screw at bottom of B-pillar.
-
Unclip and remove trim in following sequence:
-
Along molded headliner - arrow A -.
-
Right - arrow B -.
-
Left - arrow C -.
-
Remove B-pillar trim starting at clip - 1 - position.
Upper B-pillar (right), sliding door side, removing and installing
-
Clip trim onto B-pillar and into spring clips on headliner (arrow - A -), in installed position. Ensure correct installation of clip - 1 - and belt height
adjustment mechanism.
-
After installing trim, ensure correct positioning of gaskets (arrows - B - and - C -).
Lower B-Pillar Trim, Removing and Installing
Lower B-pillar Trim, Removing And Installing