Eurovan V6-2.8L (AXK) (2001)
Hydraulic Control Assembly - Antilock Brakes: Service and Repair
Bosch 5.3 ABS System
Component Notes and Information
NOTE:
^
During service procedures, refer to the illustration above and the information below
^
The hydraulic unit is located in the left front side of the engine compartment.
^
When removing and installing the brake lines/hoses, ensure they are marked and installed as per the markings on the hydraulic unit.
^
Brake lines/hoses must not be interchanged when reconnecting.
1
Tandem brake master cylinder
-
With tandem brake servo unit
2
Brake line
-
Master brake cylinder/secondary piston circuit to hydraulic unit
3
Brake line
-
Brake master cylinder/primary piston circuit to hydraulic unit
4
Brake line
-
Hydraulic unit to right front brake caliper
5
Brake line
-
Hydraulic unit to right rear brake caliper
6
Brake line
-
Hydraulic unit to left rear brake caliper
7
Brake line
-
Hydraulic unit to left front brake caliper
8
Hex nut
-
Tighten to: 8 Nm (70 inch lb)
9
Cover
10
ABS/EDL hydraulic unit
-
Bolted to control module
-
Only replace as a complete unit
11
Hex nut
-
Tighten to: 12 Nm (9 ft lb)
12
Mounting bracket
13
Bolt
-
Tighten to: 8 Nm (70 inch lb)
Special Tools Required