Eurovan V6-2.8L (AXK) (2001)
Component Notes and Information
NOTE:
^
During service procedures, refer to the illustration above and the information below
^
After servicing calipers, depress brake pedal firmly several times with vehicle stationary so that the brake pads are properly seated in their normal
operating position.
^
To remove brake fluid from the reservoir use a bleeder bottle which is used only for brake fluid
WARNING: Brake fluid is poisonous.
1
Hex bolt
-
Always replace each time after removing
-
Tightening torque on vehicles with all wheel drive:
Tighten to: 150 Nm (111 ft lb) and turn 90° further
-
All wheel drive vehicles: loosen and tighten only when vehicle is on its wheels (danger of accident)
2
Washer
3
Hex socket head bolt
-
Tighten to: 10 Nm (7 ft lb)
4
Brake rotor
-
Thickness: 13.5 mm
-
Wear limit: 11.5 mm
-
When worn always replace on both sides
5
Hex bolt
-
Tighten to: 10 Nm (7 ft lb)
6
Splash plate
7
Control arm
-
Removing and installing refer to Steering and Suspension
8
Self-locking hex nut
-
Tighten to: 200 Nm (148 ft lb)
-
Always replace
9
Tensioning disc
-
With impulse rotor for ABS speed sensor
10
Hex bolt
-
Tighten to: 170 Nm (125 ft lb)
11
Hex socket head bolt
-
Tighten to: 10 Nm (7 ft lb)
12
Speed sensor
13
Wire