Eurovan V6-2.8L (AXK) (2001)
14
Drive shaft
-
With impulse rotor for speed sensor
15
Hex bolt
-
Tighten to: 280 Nm (207 ft lb)
16
Wheel bearing housing
17
Bracket
18
ABS speed sensor
-
Before inserting sensor, clean sensor mounting hole inner surface and coat with lubricant G 000 650, or equivalent
19
Hex socket head bolt
-
Tighten to: 10 Nm (7 ft lb)
20
Hex bolt
21
Splash plate
22
Hex bolt
-
Tighten to: 8 Nm (70 inch lb)
Overhaul
Component Notes and Information
NOTE:
^
During service procedures, refer to the illustration above and the information below
^
When repairing install all parts supplied in the repair kit.
^
Apply a thin coat of assembly lubricant G 052 150 A2, or equivalent, to brake cylinders, pistons and seals.
1 Protective cap
-
Push onto bleed valve
2
Bleed valve
-
Apply thin coat of assembly lubricant G 052 150 A2, or equivalent, to threads before installing
3
Cap
-
Insert in mounting bushing
4
Guide pin
-
Tighten to: 25 Nm (18 ft lb)
5
Mounting bushing
-
Insert into brake caliper housing
6
Brake caliper housing
7
Brake carrier
-
Install on brake caliper housing
8
Retaining spring
-
Insert with both ends in holes in brake caliper housing
9
Seal
-
Removing and installing, refer below
10
Piston