Eurovan V6-2.8L (AXK) (2001)
-
Force piston out of brake caliper housing using compressed air.
NOTE: Place a piece of wood in the recess to prevent damaging the piston.
-
Remove seal using wedge 3409.
NOTE:
^
When removing the seal make sure that the surface of the cylinder is not damaged.
^
The surfaces of the piston and the seal must only be cleaned with methylated spirits and then dried.
Installation
-
Thinly coat piston and seal with assembly lubricant G 052 150 A2 before installing.
-
Place protective seal with outer sealing lip on piston.
-
Using wedge 3409, insert inner sealing lip into cylinder groove.
NOTE: Hold piston in front of caliper housing while inserting sealing lip.