Eurovan V6-2.8L (AXK) (2001)
Load Compensator: Adjustments
Special Tools And Workshop Equipment
Adjusters, Tool No. 3255
Brake System Pressure Tester, Tool No. VAG 1310A
Socket 27 mm, Tool No. 3257
Brake Pressure Regulator, Basic Setting
NOTE:
^
If for example, one or both control arms are replaced and no markings are given for the installation position of the spring mounting -2- on the
control arm, it is recommended that the basic setting procedure be done, as described below.
^
If the basic setting is not necessary, refer to Brake Pressure Regulator Fine Adjustment below.
-
Remove both shock absorbers, refer to Steering and Suspension.
-
Insert special tool 3255 and pretension control arm, refer to Brake Pressure Regulator Fine Adjustment, found below
-
Align beam -4- horizontally by sight by turning both buffer stops -1- onto stop on horizontal beam -4- (no preload at buffer stop -1-).
-
Move spring mounting -2- down until a gap (arrow) of approx. 2 mm exists on the opposite side between buffer stop -1- and horizontal beam -4-.
-
Move second spring mounting -2- down until beam -4- is again horizontal.
-
Turn both buffer stops -1- fully back, so that largest possible gap exists between horizontal beam -4- and buffer stop.