Eurovan V6-2.8L (AXK) (2001)
-
Cut tube nozzle at front marking (nozzle approximately 3 mm).
-
Apply silicon sealant to clean sealing surfaces of oil pan as shown. Sealant bead must:
-
be 2 to 3 mm thick
-
continue to inner side in area of screw holes (arrows)
Note: Sealant bead must not be thicker than specified. Otherwise, excess sealant could get into oil pan and clog strainer in intake line of oil pump.
-
Apply silicon sealant (arrows) to clean sealing surface of oil pan as shown in illustration.
-
Position oil pan immediately and tighten all oil pan screws a little bit.
-
Tighten oil pan screws to 12 Nm.
-
Tighten bolts between oil pan and transmission to 45 Nm.
Note: After installing oil pan, allow sealant to dry for approximately 30 minutes. Allow sealant to dry before adding engine oil.
The rest of the installation follows the reverse of the removal procedures.