Eurovan V6-2.8L (AXK) (2001)
NOTE: Brake pedal switch -F47- and brake light switch -F- are located together in one housing.
-
Disconnect 4-way connector from brake pedal switch and brake light switch.
-
Measure resistance between terminals 1 + 4 of switch.
Specified value
Brake not operated: Infinity Ohms
Brake operated: max: 1.5 Ohms
-
Measure resistance between terminals 2 + 3 of switch.
Specified value
Brake not operated: max. 1.5 Ohms
Brake operated: Infinity Ohms
If specified values are not obtained:
-
Replace brake light switch -F- and brake pedal switch -F47-.
If specified values are obtained:
-
Connect multimeter between terminal 1 and Ground (GND) for voltage measurement. Specification: at least 11.5 V
-
Connect multimeter between terminal 2 and Ground (GND) for voltage measurement.
-
Switch ignition on. Specification: at least 11.5 V
If specified values are not obtained:
-
Check wire between 4-pin connector terminals 1 and 2 to central electronics according to wiring diagram:
If specified values are obtained: