Eurovan V6-2.8L (AXK) (2001)
-
Check for open circuits in wires between test box and connector according to wiring diagram.
Terminal 1 + socket 98
Terminal 2 + socket 87
Terminal 3 + socket 108
Wire resistance: max: 1.5 Ohms
-
Also check wires for short circuit to each other. Specification: Infinity Ohms
If no malfunctions are found in the wires and there was voltage between terminals 1 + 3:
-
Replace Camshaft Position (CMP) sensor -G163-.
-
Check DTC memory, repair any malfunctions and then erase DTC memory.
If no errors are found in wires and there was no voltage between terminals 1 + 3:
-
Replace Engine Control Module (ECM).
-
Read readiness code. If DTC memory was erased or the Engine Control Module (ECM) was disconnected from the continuous B+ supply, the
readiness code must be re-generated. Refer to Monitors, Trip and/or Drive Cycle (Readiness Codes)/Reading Readiness Code. See: Testing and
Inspection Refer to Monitors, Trip and/or Drive Cycle (Readiness Codes)/Generating Readiness Code. See: Testing and Inspection