Eurovan V6-2.8L (AXK) (2001)
-
Disconnect the 6-pin connector at the throttle valve control module (arrow).
-
Measure resistance of throttle valve drive between terminals 3 + 5 Specification: 1.0 to 5.0 Ohms
If specified value is not obtained:
-
Replace throttle valve control module (J338).
-
Check DTC memory, repair any malfunctions and then erase DTC memory.
-
Adapt Engine Control Module (ECM) to throttle valve control module.
If specified value is obtained:
-
Check voltage supply of throttle valve control module and wiring to control module.
-
Check Throttle Position (TP) sensor and sensor 2 for accelerator pedal position:
If voltage supply and wires are OK:
-
Replace Engine Control Module (ECM).
Checking voltage supply and wiring to control module