Eurovan V6-2.8L (AXK) (2001)
With Manufacturer Scan Tool
Diagnostic Trouble Code (DTC) Memory, Checking (function 02)
NOTE: The displayed DTC information is updated only when initiating OBD or with "Erase DTC Memory" function 05.
-
Switch printer on via the PRINT button (indicator lamp in button lights up).
Indicated on display:
Rapid data transfer
HELP
Select function XX
-
Press buttons -0- and -2- to select function 02 "Check DTC memory".
Indicated on display:
Rapid data transfer
Q
02 - Check DTC Memory
-
Press -Q- button to confirm input.
Display indicates the number of stored malfunctions.
X malfunctions recognized!
The stored malfunctions are displayed and printed out in sequence.
-
Check print-out against DTC table and repair malfunction. See: Testing and Inspection/Diagnostic Trouble Code Tests and Associated
Procedures/VAG Code Charts/CAN Bus
If "No DTC recognized" is displayed, the program will return to the start position after the -> button is pressed.
No malfunction recognized!
->
Indicated on display:
Rapid data transfer
HELP
Select function XX
If something else is displayed:
-
End Output (function 06).
-
Switch off ignition and disconnect diagnostic connector.
Without Manufacturer Scan Tool
The manufacturer does not provide a procedure for reading diagnostic trouble codes without a scan tool.
With Manufacturer Scan Tool
Diagnostic Trouble Code (DTC) Memory, Erasing (function 05)
NOTE: After DTC memory is erased, its contents are automatically output. If DTC memory cannot be erased, check DTC memory again and repair
malfunction.
Requirements
-
DTC memory checked.
-
All malfunctions repaired.
After successful DTC memory check:
Indicated on display:
Rapid data transfer
HELP
Select function XX