Eurovan V6-2.8L (AXK) (2001)
Display will indicate the control module identification and the coding, e.g.:
022906032C MOTRONIC ME7.1 GV003
->
Coding 00013
WSC 00000
If this is indicated on the display, an unapproved code number has been entered.
Function is unknown or can
->
not be performed at the moment.
-
Press the -> button.
-
Press buttons -0- and -6- to select "End Output" function 06. Press -Q- button to confirm input.
-
Switch ignition off.
-
Check DTC memory, repair any malfunctions and then erase DTC memory.
NOTE: The Motronic control module uses the coding indicated on the display only after the ignition has been switched off once. Incorrect coding
causes:
-
Driveability problems (shifting pressure, tip-in shock etc.)
-
Increased fuel consumption
-
Increased emissions values
-
The storage of non-existent malfunctions in DTC memory
-
Necessary functions not being performed (oxygen sensor regulation, activation of the EVAP canister system, etc.)
-
Reduction in transmission service life
Kick-Down Shift Point, Adapting
Kick-Down Shift Point, Adapting
Vehicles with automatic transmission must have the kick-down shift point re- adapted after the Engine Control Module (ECM) is replaced and after the
accelerator pedal is replaced.
Test requirement
-
Ignition switched on, engine not running
Test sequence
-
Connect VAG1551 scan tool (VAG1552). Then switch ignition on and select the Engine Control Module (ECM) using address word 01.
Connecting scan tool and selecting ECM.
Indicated on display:
Rapid data transfer
HELP
Select function XX
-
Press buttons -0- and -4- to select "Basic Setting" function 04. Press -Q- button to confirm input.
Indicated on display:
Basic Setting
HELP