Eurovan V6-2.8L (AXK) (2001)
-
Press buttons -0- and -4- to select "Basic Setting" function 04. Press -Q- button to confirm input.
Indicated on display:
Basic Setting
Enter display group number XXX
-
Press buttons -0-, -4- and -3- to select "Display group number 43". Press -Q- button to confirm input.
Indicated on display: (1 to 4 = display fields)
System In basic setting 43
->
1
2
3
4
-
Depress brake pedal and hold down.
-
Depress accelerator pedal until it is in Wide Open Throttle (WOT) position.
NOTE: The Engine Control Module (ECM) raises engine speed to between 2000 and 2300 RPM.
-
Hold the RPM until the catalytic converter temperature in display field 2 over 350 °C climbs.
-
Check during this whether indication in display field 4 jumps from "Test OFF" to "Test ON".
-
Continue to hold brake pedal in the depressed position, until display field 4 indicates the specified value "B1-S2 OK" is indicated.
If indications do not resemble description:
-
Release brake and accelerator pedal.
-
Check oxygen sensor and oxygen sensor control behind Three Way Catalytic Converter (TWC). See: Sensor and Control Check
-
Read readiness code. Refer to Monitors, Trip and/or Drive Cycle (Readiness Codes)/Reading Readiness Code. See: Testing and Inspection
If DTC memory was erased or the Engine Control Module (ECM) was disconnected from the continuous B+ supply, the readiness code must be
re-generated. Refer to Monitors, Trip and/or Drive Cycle (Readiness Codes)/Generating Readiness Code. See: Testing and Inspection