Eurovan V6-2.8L (AXK) (2001)
Section B - 1.8 liter engine in New Beetle, GTI, Jetta and Passat vehicles
Section C - 4.0 liter engine in Passat vehicles
Section D - 2.8 liter engine in EuroVan/Rialta vehicles
Section A
Section A - 2.8 Liter Engine in Jetta and GTI
IMPORTANT:
-
If the vehicle has a MIL light on, the diagnostic trouble codes (DTCs) must be checked
-
Only cylinder misfire DTCs related to ignition coil malfunction are covered by this service action. Any other checking, diagnosis or repairs are not
part of or covered under this service action
-
If applicable, connect VAS5051 and check DTCs
-
Open hood and remove engine cover
-
Disconnect connector from all ignition coils -1-
-
Using Puller T10095, remove ignition coils
CAUTION: USE OF TOOL T10095 IS REQUIRED TO AVOID DAMAGING THESE SENSITIVE COMPONENTS
NOTE: Only ignition coils that are not one of the production levels shown on Page 2 "Parts Information" must be replaced
-
Install new ignition coils (022 905 100D/G/K) by pressing into cylinder head by hand only
IMPORTANT:
-
Do not use any object to tap ignition coil into position
-
Do not twist ignition coil when installing
-
Reconnect connectors to ignition coils
-
Reinstall engine cover
-
If vehicle is a 2002 model year Jetta with automatic transmission go to Section A1
-
If vehicle is a 2003 model year Jetta with automatic transmission go to Section A2
-
If vehicle is a Jetta or GTI with manual transmission go to Section A3
Section A1 - Wiring Harness Modification on 2002 Model Year Jetta Vehicles having a 2.8 Liter Engine with an Automatic Transmission