Eurovan V6-2.8L (AXK) (2001)
-
Disconnect 5-pin connector from Mass Air Flow (MAF) sensor -G70- with Intake Air Temperature (IAT) sensor -G42- (arrow).
-
Connect multimeter to terminal 2 of connector and engine Ground (GND) for voltage measurement.
-
Start engine, and let run at idle. Specification: 11.0 to 15.0 V
If there is no voltage:
-
Switch ignition off.
-
Check wire between 5-pin connector terminal 2 and the Fuel Pump (FP) relay -J17- for open circuit according to wiring diagram. Wire resistance:
max: 1.5 Ohms
If voltage supply and wires are OK: