Eurovan V6-2.8L (AXK) (2001)
System in basic setting 54
->
1
2
3
4
NOTE: During the function "System in basic setting", the Evaporative Emission (EVAP) canister purge regulator valve -N80- and the A/C compressor
is switched off.
Display Group 54
-
Check specified values for idle in display fields 1 through 4.
If specified values are still not obtained:
-
Perform a road test.
-
Check control module's DTC memory again.
-
Repeat idle test.
If specified values are still not obtained:
-
Check throttle valve control module. See: Computers and Control Systems/Electronic Throttle Control Module/Testing and Inspection
-
Test operating conditions of engine. Refer to Computers and Control Systems/Procedures/Operating Conditions of an Engine, Checking. See:
Computers and Control Systems/Testing and Inspection
-
Check intake system for unmetered air. See: Fuel Delivery and Air Induction/Testing and Inspection
After successful repair:
-
Read readiness code. If DTC memory was erased or the Engine Control Module (ECM) was disconnected from the continuous B+ supply, the
readiness code must be re-generated. Refer to Monitors, Trip and/or Drive Cycle (Readiness Codes)/Reading Readiness Code. See: Computers
and Control Systems/Testing and Inspection Refer to Monitors, Trip and/or Drive Cycle (Readiness Codes)/Generating Readiness Code. See:
Computers and Control Systems/Testing and Inspection