Eurovan V6-2.8L (AXK) (2001)
^
Disconnect connector from housing.
^
Carefully lift catches (3 pieces) and disconnect steering angle sensor.
^
The third catch is located at underside of the steering angle sensor.
Installing
Installation is reverse of removal, noting the following:
^
Set steering angle sensor into place until the catches engage.
If a new steering angle sensor is being installed, transportation protection must be removed.
^
Perform basic setting after installation.
Basic setting of the steering angle sensor must be checked after the following repair work:
^
If Steering Angle Sensor -G85- was removed or replaced,
^
if the steering column was removed or replaced,
^
if the steering wheel was offset.
Check basic setting of Steering Angle Sensor G85. Refer to Antilock Brakes / Traction Control Systems; Testing and Inspection.
Note: After installing the airbag steering wheel, switch on ignition and then disconnect battery Ground (GND) strap.
WARNING: Make sure no one is in the vehicle while connecting file battery Ground (GND) strap.