Eurovan V6-2.8L (AXK) (2001)
/Page-867002.png)
3 - Shaft for detent lever
^
Is secured by circlip and bearing cap of drive pinion
^
According to version with groove for circlip
4 - Return spring
^
Inserting - Refer to Fig. 4
5 - Detent lever
^
Inserting with return spring - Refer to Fig. 4
6 - Parking lock gear
^
Rounded side faces teeth of drive pinion
7 - Bolt, 14 Nm
8 - Supporting plate
^
Installing - Refer to Fig. 3
9 - Guide plate
^
Insert before supporting plate - Refer to Fig. 3
10 - Vehicle vehicle speed sensor (VSS) -G68
^
Tested in the vehicle by On Board Diagnostic (OBD).
11 - Bolt,10 Nm
12 - O-ring
^
Always replace
^
Install with ATF
13 - Bolt, 12 Nm
^
With sealing ring
^
Always replace
14 - Transmission housing
15 - Bolt, 10 Nm
16 - Lever
^
For selector shaft
17 - O-ring
^
Lever out with screwdriver
^
Drive in flush with VW 423
18 - Selector shaft with selector segment and detent segment
^
Before removing selector shaft, remove multi-function switch -F125- -item 29 - and detent spring -item 25 - Refer to Fig. 2
^
Insert together with engaging lever -item 19
^
Removing and installing - Refer to Fig. 2
19 - Engaging lever
^
Insert together with selector shaft and detent segment
20 - Spring pin
^
Drive in after inserting engaging lever - Refer to Fig. 1
^
Drive out with drift
21 - Locking washer
^
Removing and installing - Fig 2
22 - Bolt, 10 Nm
23 - Manual selector valve control
^
Always replace steel spring and bolt for manual selector valve operator
24 - Bolt, 4 Nm
^
With steel spring
^
Always replace
25 - Spring for selector segment
26 - Bolt, 10 Nm
27 - Bolt, 10 Nm
28 - Retainer
^
For multi-function switch
29 - Multi-function switch -F125
^
Insert so that 1 pin each is resting on a slope of the detent segment
^
Tested in the vehicle by On Board Diagnostic (OBD)
30 - O-ring
^
Always replace
^
Install with ATF
31 - O-ring
^
Always replace
^
Install with ATF
32 - Transmission speed sender -G38
^
Tested in the vehicle by On Board Diagnostic (OBD)
33 - Bolt, 10 Nm
