Eurovan V6-2.8L (AXK) (2001)
- Do not interchange manual selector valves of valve bodies.
- Shift selector lever/shaft into position "1".
- Pull manual selector valve out until it is just possible to unhook the operating rod -2-.
- Secure manual selector valve so that it cannot fall out.
Fig. 5 Always replace steel spring and bolt -arrow
- Remove steel spring -arrow- and lever from selector shaft in transmission.
(For better clarification the selector shaft is illustrated here in a removed state.)
Note:
^
Always replace bolt with steel spring manual selector valve.
- Install steel spring and bolt to selector shaft. Do not tighten yet!
Fig. 6 Inserting sealing plug
Pull sealing plug out of housing before removing and installing free wheel otherwise the sealing plug and the O-ring will be damaged.
- Moisten 2 new O-rings with ATF and install to sealing plug.
- Insert sealing plug in hole in transmission housing -arrow-.
Fig. 7 Identification of valve body
Code letters are stamped on a metal tab. Metal tab must remain on the valve body.