Eurovan V6-2792cc 2.8L (AES) (1998)
-
Remove seal using wedge 3409.
Installation
-
Thinly coat piston and seal with assembly lubricant G 052 150 A2 before installing.
-
Place protective seal with outer sealing lip on piston.
-
Using wedge 3409, insert inner sealing lip into cylinder groove.
NOTE: Hold piston in front of caliper housing while inserting sealing lip.
-
Screw piston into housing by turning knurled wheel clockwise.
NOTE:
^
Do not damage the protective seal when installing the piston.
^
Position special tool 3272 so that the collar (arrow) of the to9l is seated on the brake caliper
^
If the piston is difficult to move, use a 13 mm open end wrench on the flats (arrow A) provided for this purpose.
^
If the piston is pushed back with a piston resetting tool or by operating the foot brake the automatic adjustment in the brake caliper is
destroyed.
-
Install brake pads.